Water : 4 sets for every 12 meters of pipe Slurry : 7 sets for every 12 meters of pipe eg. 100m Waterpipe: (100m / 12m) x 4 = 33 Floats recommended for half submergence
PACKING GUIDE
PALLET LOAD
1.2m x 1.2m x 2.25m (height) 59 Sets per pallet Approx Weight 405Kg
*RESERVE BUOYANCY is the weight the float will carry before full submergence.
*O/D is the Outside Diameter.
*Dimensions and weights are nominal.
INCLUSIONS
A pipefloat set comprises:
2 pipefloats halves
A galvanised assembly kit which includes:
4 Rods
8 Nuts
8 Washers
SPECIFICATIONS
Manufactured from polyethylene.
Manufactured in safety orange.
Stainless steel inserts used in crush areas.
All floats are pressure tested prior to dispatch.
Recyclable and VOC Free.
Australian made and designed.
Specifications are subject to change without notice.
STAINLESS STEEL KITS
Marine Grade, SAE 316 stainless steel assembly kits for corrosive environments are available at an additional cost.
Kit includes: 4 Rods, 8 Nuts and 8 Washers.
Hosefloats Bushes
Set-up Instructions
Preparation of a Hosefloat Bush is simple 2 step process: Firmly secure the bush to a drill press
1.) Using a hole-saw kit, drill a hole to the pipe diameter first
2.) Using a saw cut the bushes in half using the cut grooves
Hosefloats bushes are made from EPDM rubber, a type of synthetic rubber. It’s main properties are heat, ozone and weather resistance. It is also resistant to polar substances and steam, with excellent electrical insulating properties and resistance to ordinary diluted acids and alkalines.